Owner`s manual

66-EN
1 Press <MENU>.
The AUDIO/VISUAL selection screen is displayed.
2 Touch [CD/DVD].
The display shows the DVD/Disc mode screen.
The unit starts to play the disc.
• You can select the DVD/Disc mode also by pressing <SOURCE/
PWR> repeatedly.
• The display mode can be changed by touching [WIDE].
For operation, see “Switching Display Modes” on page 71.
• Refer also to “DVD Setup” (pages 111 to 113).
• While “Reading INDEX” is displayed by DivX
®
, the fast-
forwarding/fast-reversing and repeat functions, etc., cannot be used.
• A file that exceeds 2GB cannot be played back.
On DVDs, menu screens may appear automatically. If this happens,
perform the operation described below to start playback.
Direct Menu Operations
1 Touch the DVD menu directly.
• Some operations cannot be performed depending on the
disc.
Menu Operations
1 Touch [ ].
The menu operation mode will be displayed.
• If you touch [Goup], the display changes to the MENU
screen, etc. The displayed screen type may differ
depending on the disc.
2 Select a desired menu item by touching [ ], [ ],
[] or [].
3 Touch [Enter] to confirm the selected item.
Caution
• Not all functions will operate for every DVD. See the
individual DVD’s instructions for details on the
features supported.
• Fingerprints on a disc may adversely affect
playback. If a problem occurs, remove the disc and
check for fingerprints on the playback side. Clean
the disc if necessary.
• If you switch the power or Ignition key OFF or
change sources during playback, playback will
continue where you left off when you resume
playback.
• If you try to perform an invalid operation (based on
the type of disc being played), the following mark is
displayed on the monitor screen:
Play Position Memory Function
Even if you turn power off or switch the Ignition key to OFF
during playback or change the source, playback will
continue from the point where playback stopped when the
power is turned ON again.
If a menu screen appears