Owner`s manual

137-EN
4 Mounting the Microphone.
For safe use, make sure of the following:
• location is stable and firm.
• driver’s view and operations are not obstructed.
• microphone is located where the driver’s voice can be easily
picked up (near the sun visor, etc.).
When you speak into the microphone, you should not have
to change your driving posture. This may cause a
distraction, taking your attention away from safely driving
your vehicle. Carefully consider direction and distance while
mounting the microphone. Confirm that the driver’s voice
can be easily picked up at the selected location.
5 Remove the mounting sleeve from the main unit (see
“Removal” on page 137).
Slide the mounting sleeve into the dashboard and fix
it with the metal shackles.
*
1
If the installed mounting sleeve is loose in the dashboard, the
pressure plates may be bent slightly to remedy the problem.
*
2
The supplied face plate may be mounted.
6 When your vehicle has the Bracket, mount the long
hex bolt onto the rear panel of the INE-S900R and
put the Rubber Cap on the hex bolt. If your vehicle
does not have the Mounting Support, reinforce the
head unit with the metal mounting strap (not
supplied). Secure the ground lead of the unit to a
clean metal spot using a screw (*
1
) already attached
to the vehicle’s chassis. Connect all the leads of the
INE-S900R according to details described in the
CONNECTION section.
• For the screw marked “*
2
”, use an appropriate screw for the chosen
mounting location.
7 Slide the INE-S900R into the dashboard until it
clicks. This ensures that the unit is properly locked
and will not accidentally come out from the
dashboard.
Removal
1 Insert the bracket keys into the unit, along the guides on
either side. The unit can now be removed from the
mounting sleeve.
2 Pull the unit out, keeping it unlocked as you do so.
Cable clamp
(Sold separately)
Microphone
Mounting Sleeve
(Included)
Dashboard
Rubber Cap (Included)
Face Plate
*
2
(Included)
This unit
Hex Bolt
(Included)
Bracket
Pressure
Plates
*
1
Hex Nut (M5)
Screw
Bolt Stud
This unit
Chassis
Ground Lead
Metal
Mounting
Strap
*
2
*
1
This unit
Bracket keys
(Included)