Owner`s manual

126-EN
MP3/WMA/AAC is not played
back.
Writing error occurred. The CD format is not
compatible.
Make sure the CD has been written in a supported
format. Refer to “About MP3/WMA/AAC” (pages 63 and
64), then rewrite in the format supported by this device.
Unit does not operate. Condensation. Wait a while (about 1 hour) for the condensation to dry.
Playback does not start. Disc is loaded upside-down. Check the disc and load it with the labeled side facing
upward.
Disc is dirty. Clean the disc.
A disc not able to play back with this unit is
loaded.
Check if the disc is able to be played back.
Parental lock is set. Cancel the parental lock or change the rating level. (See
page 112.)
Picture is unclear or noisy. Disc is being fast-forwarded or fast-reversed. The picture may be slightly disturbed, but this is normal.
Vehicle’s battery power is weak. Check the battery power and wiring. (The unit may
malfunction if the battery power is under 11volts with a
load applied.)
Image stops sometimes. Disc is scratched. Replaced with a non-scratched disc.
Unable to input the passcode in
the DVD setup screen./Unable to
remember the passcode.
The passcode is different. Restore the DVD Setup to the default setting, then erase
the memorized passcode. (See page 113.)
iPod/iPhone is not played back.
Sound of iPod/iPhone is not
output.
The iPod/iPhone is not recognized. Reset the iPod/iPhone. For details about resetting iPod/
iPhone, refer to the User’s Guide of the iPod/iPhone.
Symptom Cause Solution