Owner`s manual

113-EN
Use the procedure described below to modify the output screen
according to the type of TV monitor (rear monitor) being used.
This setting can also be applied for the INE-S900R.
If the rear monitor is not connected, the screen setting is 16:9.
Setting item: TV screen
Setting contents: 16:9 (Initial setting) / 4:3 LB / 4:3 PS
1 Touch [TV screen].
Every time you touch, the setting contents will be changed.
4:3 LETTER BOX:
Select this when connected to a conventional 4:3 size
(normal TV aspect ratio) monitor. There may be black
stripes visible at the top and bottom of the screen (when
playing a 16:9 size movie). The width of these stripes will
depend upon the original aspect ratio of the theatrical
release of the movie.
4:3 PAN-SCAN:
Select this when connected to a conventional 4:3 size
monitor. The picture will fill the entire TV screen. However,
due to the mismatch in aspect ratio, parts of the movie at
the extreme left and right sides will not be visible (when
playing a 16:9 size movie).
16:9 WIDE:
Select this when connected to a wide screen TV. This is the
factory setting.
This function applies to Dolby Digital, DTS stream sound.
Setting item: Downmix mode
Setting contents: Surround (Initial setting) / Stereo
1 Touch [Downmix mode].
Every time you touch, the setting contents will be changed.
Surround: Surround compatible Downmix
Stereo: Stereo Downmix
Resets the DVD setup content to the factory settings.
Setting item: Reset
1 Touch [Reset] in the DVD Setup screen.
The confirmation dialog screen appears.
2 Touch [Yes].
The settings are initialized.
Setting the TV Screen Mode Setting the Downmix Mode
Resets DVD setup