Owner's Manual
Table Of Contents
10
After selecting a Target curve, double-click the
Send
Filter
button to transfer the
settings to the PXA-H100. Choose either
Curve
Memory
1 or
Curve
Memory
2 to
store
in
PXA-H100 memory.
•
You
can
slOre
two curve settings
for
one measurement result.
11
If you are not satisfied with the measurement result, you can start from the procedure
in
step 7
by
double-clicking the
He-Measure
button.
•
I(you
fJelform the measurement again using the Re-Measure button, note that the previously stored settings
ill
the PXA-H100 will be cleared
and
replaced
by
the new one.
12
When the memory setting is complete, click x on the right side of the screen and
double-clicking
OK
on the EXIT screen to close the IMPRINT SOUND MANAGER
programme.
13
After you have finished the MultEQ calibration, disconnect the USB Cable from the
PXA-H100.
14
Now, relax and enjoy the fruits of your labour with the newly, IMPRINT optimized
system. By turning MultEQ on and off with this just calibrated Alpine head unit, the
benefits of calibration are obvious.
For
details
on
operating this IMPRINT compatible Alpine head unit, refer to its Owner's Manual.
About
Trademark
• Audyssey MultEQ
XT
is a registered trademark
of
Audyssey Laboratories Inc.
• Microsoft and Windows are trademarks,
or
registered trademarks
of
Microsoft Corporation in the United
States and/or other countries.
6-EN