Owner's Manual

7 When microphone placement is complete, get out of the vehicle, and close all doors,
windows and sunroof. Then, start measurement
by double-clicking the Measure
button on the IMPRINT SOUND MANAGER screen. Do not open the doors until
"Complete" is displayed on the screen and signal sound is output from the speakers
and sound characteristics are measured
in the vehicle. If noise enters from outside
during measurement, "Error" will be displayed on the screen. If displayed, measure
again by double-clicking the
Measure button.
I
o Peljonn PC operation outside the vehicle.
o Rell1ol'ing the microphone during calibration ma}' cause an error.
8 After measuring the first microphone position, move the microphone to the next
location indicated by the on the screen graphic. Repeat the procedure
in step 7
following the on screen instructions.
o Pre!,onning measurement from two locations in the car should be su./ficient. If you want to finish (titer two
measuremelltlocations, double-clicking the
Result button, and move to the Tw'!?et Curl'e setting.
o For more precise measurement, 6 measurement locations are available; however, it will take approx. 20 minutes
until all MultEQ measurements have been completed.
In this case, be sure to peljrmn MultEQ measurement
with the vehicle connected to a
car battery charger.
9 After all desired mic position measurements are complete, double-click the Result
button to make the Target Curve selection. This curve sets the overall sound
characteristics of the system. Select the
Target Curve Select from the on screen
choices.
o The measurement data cannot be stored on the PC hard disc, but can be memorized in the PXA -H100.
5-EN