Owner's Manual

Table Of Contents

Mounting The Stereo Continued

4. Remove plastic panel located beneath the

steering wheel column and access the bundle

of wires which houses the Green/Black wire.

Connect the Green/Black wire coming from

the vehicle side connections of the interface

to this wire. This is a data signal so to ensure

consistent operation please solder the wires

together. DO NOT cut this wire in half.

Steering Wheel Controls

Steering Wheel Control Operation

(when vehicle is equipped)

1. Mute/OnStar Activation**

2. End Call

3. Seek/Track Up

4. Seek/Track Down

5. Volume Up

6. Volume Down

3. If you wish to retain the factory rear view camera

you must solder an RCA end onto the signal wires. The

wires you will need can be found at the Human Machine

Interface Control Module (HMICM). This module is located

behind the lower glove box and can be accessed by

removing the 4 - T15 bolts securing the lower glove box

to the dash. Once you have located the HMICM in the

vehicle, locate the 12 pin connector on the far left. If the

vehicle has the base radio (RPO code IO3 behind glove

box) the wires will be in the 8 pin connector located at the

radio brain. The wires you will need are located in pins

5 and 6 in either connector. Pin 6 - White/Blue - Camera

Negative, Pin 5 - Grey/Yellow - Camera Positive.

5. Mount radio and climate controls in trim

panel in the dash. Use (4) 7mm screws from

step 2 of factory stereo removal. Snap factory

dash trim piece back into place.

** The Voice button has two functions. Pressing this

button for less than 1.5 seconds will initiate the mute

command. Pressing this button for more than 1.5

seconds will activate OnStar.

Behind steering wheel

(Driver Side)

Behind steering wheel

(Passenger Side)