Owner's Manual

Factory Stereo Removal
2
1. Attach the left and right side brackets to
the head unit using screws supplied with
head unit and then attach to trim panel.
Attach climate controls (from previous step)
to trim panel.
2. Move the silver telematics module
down to where the CD player used to be.
Cut out the plastic between the top two
module locations so there’s enough space
for the wiring harness and radio chassis.
Install Bluetooth Mic, foot brake & parking
brake wires, and GPS antenna. Plug in the
harness and module. Note: If telematics
module is left unplugged, the vehicle will
not start.
1. Unsnap and remove center dash trim piece from
around the radio and climate controls.
2. Remove (4) 7mm screws from the radio and climate
controls.
3. Remove the tuner and CD player.
4. Remove the climate controls by carefully
unclipping from factory panel. These will later
be installed into the main trim panel.
Mounting The Stereo