Owner's Manual

Perfect Fit For Select 2014+ Chevrolet/GMC Trucks (No
Bose System) Installation Manual
KTX-GM8K2
15A
Power Harness x 1
Introduction
This KTX-GM8K2 Perfect Fit installation kit is for Select 2014+ Chevrolet/GMC Trucks (without the
Bose system). Included are all the parts needed to install your Alpine INE-Z928HD or Alpine X008
Audio Video Navigation system. KTX-GM8K2 Perfect Fit installation kit also includes an interface
that will retain factory features such as OnStar, vehicle settings, steering wheel controls (SWC),
front and rear park assist and warning chimes when the original radio is removed. It also provides
data bus driven outputs such as retained accessory power (RAP), vehicle speed sensor (VSS),
illumination, reverse trigger and parking brake. Refer to the individual instruction sections of this
manual to remove your vehicle’s factory radio and assemble the kit.
Caution! Disconnect your vehicle’s negative battery terminal before the installation to
help prevent electrical damage. We recommend the use of a digital multimeter to check
vehicle wiring. Do not use a test light! A test light or grounded wire probe can cause
damage to the vehicle’s computer and/or diagnostic systems. Avoid all factory airbag
wiring. Airbags can accidentally deploy causing serious injury or even death.
Notes:
• See your vehicle’s instructions for any special tools your installation might require.
• Read all instructions accompanying your car stereo for proper wiring and mounting
instructions.
GM Antenna
Adapter
Left Bracket x 1
Right Bracket x 1
GM Trim Panel x 1 Radio Replacement and
Steering Wheel Module
x 1
1

Summary of content (8 pages)