Owner's Manual
Lh
WARNING
This symbol means important instructions. Failure
to heed them can result
in
serious injury or death.
KEEP
SMALL
OBJECTS
SUCH
AS
SCREWS
OUT
OF
THE
REACH
OF
CHILDREN.
Swallowing them may result
in
serious injury. If swallowed, consult a
physician immediately.
USE
ONLY
IN
CARS
WITH
A
12
VOLT
NEGATIVE
GROUND.
(Check with your dealer
if
you are not sure.) Failure to do so may result
in
fire, etc.
DO
NOT
SPLICE
INTO
ELECTRICAL
CABLES.
Never cut away cable insulation to supply power to other equipment.
Doing so will exceed the current carrying capacity
of
the wire and result
in
fire or electric shock.
DO
NOT
DAMAGE
PIPE
OR
WIRING
WHEN
DRILLING
HOLES.
When drilling holes
in
the chassis for installation, take precautions so
as not to contact, damage
or
obstruct pipes, fuel lines, tanks or electrical
wiring. Failure to take such precautions may result
in
fire.
MAKE
THE
CORRECT
CONNECTIONS.
Failure to make the proper connections may result
in
fire
or
product
damage.
CHECK
THAT
THE
CAMERA
MOUNTING
BRACKET
IS
ATTACHED
SECURELY,
AND
THAT
THE
SCREWS
ARE
TIGHT
BEFORE
DRIVING.
Failure to do so may result
in
an accident.
WHEN
INSTALLING
THE
CAMERA,
OR
WHEN
CHECKING
IT
IS
INSTALLED
SECURELY,
DO
SO
AFTER
PARKING
THE
CAR
IN
A
LEVEL,
SAFE
PLACE,
TURNING
OFF
THE
ENGINE,
AND
APPLYING
THE
HAND
BRAKE.
Failure
to
do so may result
in
an accident.
WHEN
USING
A
DRILL
TO
MAKE
A
HOLE,
TAKE
PRECAUTIONS
SUCH
AS
WEARING
GOGGLES
SO
FRAGMENTS
DO
NOT
GET
INTO
THE
EYES.
Failure to do so may result
in
injury.
Lh
CAUTION
This symbol means important instructions. Failure
to heed them can result
in
injury or material
property damage.
USE
SPECIFIED
ACCESSORY
PARTS
AND
INSTALL
THEM
SECURELY.
Be sure to use only the specified accessory parts. Use
of
other than
designated parts may damage this unit internally
or
may not securely
install the unit
in
place. This may cause parts to become loose resulting
in
hazards or product failure.
HAVE
THE
WIRING
AND
INSTALLATION
DONE
BY
EXPERTS.
The wiring and installation
of
this unit requires special technical skill
and experience. To ensure safety, always contact the dealer where you
purchased this product to have the work done.
ARRANGE
THE
WIRING
SO
IT
IS
NOT
CRIMPED
OR
PINCHED
BY
A
SHARP
METAL
EDGE.
Route the cables and wiring away from moving parts (like the seat rails)
or
sharp
or
pointed edges. This will prevent crimping and damage to the
wiring.
If
wiring passes through a hole
in
metal, use a rubber grommet to
prevent the wire's insulation from being cut by the metal edge
of
the hole.