Owner`s manual

18-EN
01GB07TMEM860.fm
ALPINE TME-M860 68-04123Z81-B (EN)
4 Remove the main unit from the stand.
5 Remove the mount from the stand and stick it to the
dashboard etc.. Remove any dirt on the place to
install, using the supplied cloth.
• If the temperature in the car is low (Winter), then first heat up the
place where you are going to stick the mount with a hairdryer etc.
• Do not apply force to the mount, or expose to humidity, within 24
hours after attaching.
• If the mount is not firmly stuck, then we recommend that you attach
with the supplied fixing screws.
6 Attach the main unit to the stand as shown in step 2.
Use the cable clamps to fix the cables.
• Before using, check that the main unit and the stand, and the stand
and the place where it is attached to the car are fixed securely.
Parking Brake Lead Connection
If necessary, use a pinch connector to connect the parking brake lead,
etc.
Fixing screws
(M4 x 12 Supplied)
If the place of
attachment is
curved, then
bend this
part to match
the shape.
Mount
1
2
To prevent external noise from entering the audio system.
• Locate the unit and route the leads at least 10 cm away
from the car harness.
• Keep the battery power leads as far away from other
leads as possible.
• Connect the ground lead securely to a bare metal spot
(remove any paint, dirt or grease if necessary) of the car
chassis.
• If you add an optional noise suppressor, connect it as far
away from the unit as possible. Your Alpine dealer carries
various noise suppressors, contact them for further
information.
• Your Alpine dealer knows best about noise prevention
measures so consult your dealer for further information.
Vehicle Cable
Pinch Connector
Monitor Cable
Stopper
Pliers
01GB00TMEM860.book Page 18 Wednesday, February 22, 2006 11:30 AM
130.com.ua
Autogood products internet store http://130.com.ua