Owner`s manual

8-EN
01GB06TMEM860.fm
ALPINE TME-M860 68-04123Z81-B (EN)
Visual EQ Setting Operation
1 Press and hold SOURCE for at least 2 seconds.
The SETUP selection screen is displayed.
2 Touch [Visual EQ].
VISUAL EQ screen appears.
3 Select a desired setting item by touching [ ] or [ ].
Setting items:
BRIGHT COLOR* TINT* CONTRAST SHARP*
VISUAL EQ MODE* USER MEMORY*
* The setting is available in the visual source mode. (except RGB
navigation screen)
4 Change the setting on the selected item by touching
its [] or [].
5 Touch [RETURN] to return to the normal screen.
• Visual EQ setting cannot be made in the CAMERA mode.
You can select a mode suitable for the subject image.
Setting item: VISUAL EQ MODE
Setting contents: OFF / NIGHT M / SOFT / SHARP / CONTRAST /
P-1 / P-2
• To return to the initial setting, after selecting any one of the setting
contents (NIGHT M to CONTRAST) and adjusting a desired
brightness, picture tint, etc., set this function to OFF.
• If your desired brightness, picture tint, etc., are adjusted after
selecting any one of the setting contents, “CUSTOM” is displayed.
You can store the settings made for “Adjusting Image Brightness, Tint,
Depth, Picture Quality and Contrast.”
Setting item: USER MEMORY
Setting contents: P-1 / P-2
1 After completing “Adjusting Image Brightness, Tint,
Depth, Picture Quality, and Contrast” (pages 8, 9), touch
[] or [] of USER MEMORY and then select preset
number “P-1” or “P-2” to which the settings are to be
stored.
2 After selecting a preset No., touch [WRITE].
The adjusted VISUAL EQ mode is stored by the above
operations.
• You can recall the VISUAL EQ mode stored here from P-1 or P-2 of
“Selecting the VISUAL EQ Mode (Maker’s setting)” (page 8).
Setting item: BRIGHT
Setting contents: -15 ~ +15
You can adjust the brightness between MIN (–15) and MAX
(+15). When it reaches the minimum or maximum point, the
display shows “MIN” or “MAX” respectively.
• The brightness is automatically adjusted according to the car's
interior brightness if AUTO is set in “Setting the Brightness of the
Backlighting” (page 6).
VISUAL EQ™
The following steps 1 to 5 are common operations to each
“Setting item” of VISUAL EQ setting. Refer to each section for
details
Selecting the VISUAL EQ Mode (Maker’s
setting)
OFF: Initial Setting
NIGHT M: Suitable for movies in which dark scenes
frequently appear.
SOFT: Suitable for CGs and animated films.
SHARP: Suitable for old movies where images are not
clearly shown.
CONTRAST: Suitable for recent movies.
P-1: Recalls the VISUAL EQ mode being stored on
preset No.P-1 from “Storing VISUAL EQ” (page 8).
P-2: Recalls the VISUAL EQ mode being saved on
preset No.P-2 from “Storing VISUAL EQ” (page 8).
Storing VISUAL EQ
Adjusting Brightness
01GB00TMEM860.book Page 8 Wednesday, February 22, 2006 11:30 AM
130.com.ua
Autogood products internet store http://130.com.ua