Owner's Manual

~ n---,
J10
"" l 11
J22
~21
Pin
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
f~--~
18----~
17-------~
Color
Purple/ black
Green I black
Gray I black
White / black
NC
Purple / black
Green I black
Gray I black
White / black
Yellow
Yellow
Purple
Green
Gray
White
Blue/white
Purple
Green
Gray
White
Black
Black
function
Audio Input, Rear right(-)
Audio Input, rear left(-)
Audio Input, front right(-)
Audio Input, front left (-)
Audio Output, rear right(-)
Audio Output, rear left(-)
Audio Output, front right(-)
Audio Output, front left(-)
Battery, Positive leads
Battery, Positive leads
Audio Input, Rear right(+)
Audio Input, rear left(+)
Audio Input, front right(+)
Audio Input, front left(+)
Remote on
Audio Output, rear right ( +)
Audio Output, rear left(+)
Audio Output, front right ( +)
Audio Output, front left(+)
Ground
Ground
Fig.1
CONNECTIONS (Fig. 1)
Before making connections, be sure to turn the power off to all audio components. Connect the
yellow battery lead from the amp directly to the positive(+) terminal of the vehicle's battery. Do
not connect this lead to the fuse block.
it, CAUTION
♦ Caution on connection terminals/parts
• Keep electrically conductive objects away from the unit's terminals/parts (power terminals,
fuses, speaker output terminals, RCA connectors, etc.). Doing so prevents a possible short
circuit and damage to the unit.
• Use appropriate electrical source. The person installing this will choose the appropriate
electrical source.
To prevent external noise from entering the audio system.
• Locate the unit and route the leads at least 10 cm (3-15/16") away from the car harness.
• Keep the battery power leads as far away from other leads as possible.
• Connect the ground lead securely to a bare metal spot
(remove any paint or grease if necessary) of the car chassis.
• Your Alpine dealer knows best about noise prevention
measures so consult your dealer for further information.
CD Input/Output/Power Connector
(2) lnput/Output/PowerWire Harness
® Speaker Output Leads
Be sure to observe correct speaker output connections in the system. Connect the positive
output(+) to the positive speaker terminal and the negative output(-) to the negative speaker
terminal.
Note:
• Do not connect speaker leads together or to chassis ground.
® Input Signal Leads
There are two options:
a) RCA Input Jacks
Connect these jacks to the line out leads on your head unit, you may or may not require
extension cable.
b) Speaker Level Inputs
Note:
Cut off the RCA jacks, then connect the correct corresponding speaker outputs from the
head unit directly to these twisted pair wires.
• For the •speaker Level Input System" setting, connecting the Remote Turn-On Lead is not
required due to the "REMOTE SENSING" function of this product. However, the "REMOTE
SENSING" function may not work depending on the signal source connected. In such a case,
connect the Remote Turn-On Lead to an incoming power supply wire (accessory power) in
the ACC position.
@ Ground Lead (Black)
Connect this lead securely to a clean, bare metal spot on
the vehicle's chassis. Verify this point to be a true ground by checking for continuity between
that point and the negative (-) terminal of the vehicle's battery. Ground all your audio
components to the same point on the chassis to prevent ground loops.
® Battery Lead (Yellow)
Connect battery lead directly to BATT +
Be sure to add a 20A fuse (sold separately) as close as possible to the battery's (+) terminal.
(/) Remote Tum-On Lead (Blue/White)
Connect this lead to the remote turn-on or power antenna (positive trigger, (+) 12V only) lead
of your head unit.