Owner's Manual

47-EN
Accessory List
Main unit............................................................................................................. 1
Power cable........................................................................................................1
USB extension cable .......................................................................................1
PRE OUT cable................................................................................................... 1
Microphone ....................................................................................................... 1
Owner’s Manual ......................................................................................... 1set
Installation
Angle of installation
Install at an angle between horizontal and 30°. Note that installing at
an angle outside of this range will result in a loss of performance and
possibly damage.
For safe use, make sure of the following:
• Location is stable and firm.
• Does not interfere with safety equipment.
• Driver’s view and operations are not obstructed.
• Microphone is located where the driver’s voice can be easily
picked up (for example, on the sun visor).
When you speak into the microphone, you should not have to change
your driving posture. This may cause a distraction, taking your
attention away from safely driving your vehicle. Carefully consider
direction and distance while mounting the microphone. Confirm that
the driver’s voice can be easily picked up at the selected location.
1 Mount the original mounting bracket to the unit using
the supplied screws.
2 Connect all other leads of the unit according to details
described in the “Connections” (page 48).
3 Mount the unit in a car.
* To securely connect the ground lead, use an already installed screw on a
metal part of the vehicle (marked ( )) or a clean, bare metal spot on the
vehicle's chassis.
• Fix the cables carefully. Do not damage them by mounting them into
movable parts, such as the seat rail, or by locating them against sharp or
pointed edges.
4 Reattach the removed vehicle parts (panels, etc.) or
other aftermarket dash kit back onto the vehicle.
Caution concerning the installation location
Mounting the Microphone
Caution
• Do not block the unit’s fan, thus preventing air
circulation. If blocked, heat will accumulate inside
the unit and may cause a fire.
Heat sink
Rear of the Unit
0 - 30°
Installation example using the Original
Mounting Bracket
Microphone
Cable clamp
(sold separately)
Original Mounting Bracket
Screws (M5×8)
(included)
Ground Lead*
Chassis