Owner's Manual
Table Of Contents
- Alpine Receiver
- Owner's Manual
- Contents
- Operating Instructions
- Getting Started
- Setup
- General Setup
- Connection (Bluetooth) Setup
- Camera Setup
- Sound Setup
- Apple CarPlay (Optional)
- Android Auto (Optional)
- Radio/HD Radio™/RBDS
- Radio Basic Operation
- Listening to the Radio
- Presetting Stations Manually
- Presetting Stations Automatically
- Tuning to Preset Station
- Receiving a Multicast (HD Radio™ Mode only)
- Forced Analog Mode
- Selecting the Receivable Program Type (RBDS FM Radio Mode only)
- Using Ballgame Mode (HD Radio™ Mode only)
- Displaying Radio Text (HD Radio™/RBDS FM Radio mode only)
- About the Feature Logos
- USB Flash drive (Optional)
- USB Audio
- USB Video
- USB Photo
- iPod mode on iPhone (Optional)
- SiriusXM Satellite Radio Operation (Optional)
- HDMI Device (Optional)
- Bluetooth Operation
- Hands-free Phone Control
- Bluetooth Audio
- Auxiliary Device (Optional)
- Camera Operation (Optional)
- iDataLink Operation
- Information
- Installation and Connections
- LIMITED WARRANTY
- Quick Reference Guide
- Warranty
- Owner's Manual
- Alpine Amplifier
Installation
Note on installation
• Install at
an
angle between horizontal and
30°.
Note that installing at an angle outside
of
this
range will result in a
loss
of
performance and
possible damage.
\
•
....
• Do not block the unit's heat
sink,
which would
prevent air circulation
If
blocked, heat will
accumulate inside the unit and may
cause
a
fire.
Heat
sink
=
1111
li!!!ii.
=
0
000000000
r.iil
0
il!!i
@@
~
•
000
000
° 0
F::umnj
~
Rear
of
the
Unit
Mounting
the
Microphone
For
safe
use.
make sure
of
the
following:
Location
is
stable and firm.
Driver's
view
and operations are
not
obstructed.
Microphone
is
located
where
the
driver's voice can
be
easily picked
up
(on
the
sun visor, etc.).
When you speak
into
the
microphone, you should
not
have
to
change
your
driving
posture. This may cause a
distraction, taking
your
attention
away from safely
driving
your
vehicle. Carefully consider
direction
and
distance
while
mounting
the microphone. Confirm
that
the
driver's voice can be easily picked
up
at
the
selected location.
12-EN
Owner's manual
Installation
Microphone
Installing
the
Unit
1
Mount
the original mounting bracket
to
the
unit
using
the
supplied screws.
Original
Mount
i
ng
Bracket
2
Ground Lead*
Chas
si
s
Screws (MS x 8)
(included)
Connect all
other
leads
of
the
unit
according
to
details described in
the
"Connections" (page 14).
3 Mounting
the
unit
in a car.
•
To
securely connect the ground
lead,
use
an
already
installed screw on a metal part
of
the
vehicle
( marked
(*))
or a
clean,
bare
metal spot
on
the
vehicle's
chassis.
•
Fix
the
cables
carefully.
Do
not damage them by tucking
them into movable parts,
such
as
a seat
rail,
or
by
locating them against sharp or pointed
edges.