Owner`s manual

38-EN
Installation
• Stick the supplied cover sheet on the surface of the unit.
•
•
•
•
• The main unit must be mounted within 35 degrees of the horizontal
plane, back to front.
Removal
1. Remove the detachable front panel.
2. Use a small screwdriver (or similar tool) to push the
locking pins to the “up” position (see above drawing).
As each pin is unlocked, gently pull out on the unit to
make sure it does not re-lock before unlocking the
second pin.
3. Pull the unit out, keeping it unlocked as you do so.
Caution
Do not block the unit’s heat sink, thus preventing air circulation.
If blocked, heat will accumulate inside the unit and may cause a
fire.
Caution
When you install this unit in your boat, do not remove the
detachable front panel.
If the detachable front panel is removed during installation, you
might press too hard and warp the metal plate that holds it in
place.
Heat sink
Detachable
Front Panel
Cover sheet
Less than 35°
1
* If the installed mounting sleeve is loose in the instrument panel, the
pressure plates may be bent slightly to remedy the problem.
Remove the mounting sleeve from the main unit (see
“Removal” on page 38). Slide the mounting sleeve
into the Instrument Panel and fix it with the metal
shackles.
2
When your boat has the Bracket, mount the long hex
bolt onto the rear panel of the iDA-X100M and put
the Rubber Cap on the hex bolt. If your boat does
not have the Mounting Support, reinforce the head
unit with the metal mounting strap (not supplied).
Connect all the leads of the iDA-X100M according to
details described in the CONNECTIONS section.
• For the screw *, provide a proper screw to the hull installing location.
3
Slide the iDA-X100M into the Instrument Panel.
When the unit is in place, make sure the locking pins
are fully seated in the down position. This can be
done by pressing firmly in on the unit while pushing
the locking pin down with a small screwdriver. This
ensures that the unit is properly locked and will not
accidentally come out from the Instrument Panel.
Install the detachable front panel.
Pressure Plates*
Instrument Panel
This unit
Mounting Sleeve
(Included)
Bracket
Rubber Cap
(Included)
Hex Bolt
(Included)
Metal Mounting Strap
Screw
Bolt Stud
This unit
Hex Nut (M5)
Lock pin
This unit