Owner`s manual

13-EN
Use the SETUP menu to flexibly customize the unit to suit your own
preferences and usage. Choose settings from General, Display, etc., to
make the desired changes.
1 Press SETUP to activate the SETUP selection mode.
2 Slide the LIST switch in the direction of or
to select the desired item, and then press /
ENTER.
Transmitter Bluetooth Audio General Display
iPod (e.g. Select General)
3 Slide the LIST switch in the direction of or
to select a setting item, and then press /
ENTER.
(e.g. Select Beep)
Transmitter:
Frequency
Bluetooth:
Pairing Mode* Paired Phone Paired Audio Clear
Devices Pass Code Auto Connect Auto Answer
HFP Volume HFP Speaker
Audio:
Factory’s EQ
General:
Language Beep Demo Output Mode
Auto Poweroff
Display:
Dimmer Level Text Scroll BGV Select
iPod:
Artwork Display Artwork Type Playlist Artist
Album Podcast Audiobook Genre Composer
Song
* Refer to “How to connect to a Bluetooth compatible device
(Pairing)” (page 5).
4 Slide the LIST switch in the direction of or
to change the setting, and then press /
ENTER.
(e.g. Select Beep On or Beep Off.)
5 Press and hold / for 2 seconds to return to
normal mode.
• Pressing / during the procedure will return to the previous
mode.
Select Transmitter from the setup main menu in step 2.
FM Transmitter Function (Frequency)
Frequency 88.1–107.9 MHz
You can listen to sound of the unit from the FM car radio. Match the
frequency set and stored in the unit with the frequency of the car radio.
1 Slide the LIST switch in the direction of or
to select the frequency you want to change,
and then press and hold /ENTER for at least 2
seconds.
The frequency setting mode is activated.
2 Slide the LIST switch in the direction of or
to tune the desired frequency, and then press
/ENTER .
The frequency is stored.
• If unit sound is interfered with by other FM radio stations, change to
another frequency.
• Recommended frequencies should be more than 0.4MHz from the
interfering FM radio station.
• Volume is adjusted on the radio side.
• When the radio frequency is tuned, automatic radio tuning may
continue. In this case, tune the radio station manually.
• Actual transmission reach of the FM transmitter is approx. 1.5 m.
Depending on placement, you may not be able to listen to the radio.
Place the transmitter where radio sensitivity is good.
• While setting, pressing / will cancel the frequency you
previously set.
Recall the stored frequency.
Slide the LIST switch in the direction of or to
select a frequency, and then press /ENTER.
The selected frequency is recalled.
SETUP
Follow steps 1 to 5 to choose an item to change. See
the individual item descriptions following Step 5 for
further details.
/ENTER
SETUP
/
LIST
LIST
Transmitter Setting
■ Storing a Frequency
■ Recalling the Stored Frequency