Owner`s manual

Installation
Q~ Delao",la. From
V Panel
Caution
Whell yOLl illSwll this L1llit ill YOLlr car, do Ilot remove the
detachable frollt pallel.
If the detachable frollt pallel is remOl'ed dLlrillg illstallalioll, yOLl
might press too hard alld warp the metal plate that holds it ill
place.
Reinforce the head unit with the metal mounting
strap (not supplied). Secure the ground lead
of the
unit to a clean metal spot
using a screw (*1) already
attached to the vehicle's chassis.
• For the screw marked" *2", LIse all approprime screw for the chosell
mOLlll/illg locatioll.
Connect each input lead coming from an amplifierto
the corresponding output lead coming from the left
rear
of the CDE-l02. Connect all other leads of the
CDE-l02 according to details described in the
CONNECTIONS section.
3 Slide the CDE-l02 into the dashboard until it clicks.
This ensures that the unit is properly locked and will
not accidentally
come out from the dashboard.
Install the detachable front panel.
• The maill L1llitmLlst be mOLlllted withill 35 degrees of the hori~oll/al
plalle, back to frail I.
Less than 35°
1
Mounting Sleeve
(Included)
This unit
Dashboard
Removal
1 Remove the detachable front panel.
2 Insert the bracket keys into the unit, along the guides
on either side. The unit can now be removed from the
mounting sleeve.
This unit
~.~ Bracket Keys
~' ~ (Included)
~
3. Pull the unit out, keeping it unlocked as you do so.
<JAPANESE CAR>
~n
~+R
Front Frame
* (( the illstalled IlIOWltillg sleeve is loose ill the dashboard, the
pressLlre plates may be bellt slightly to remedy the problem.
Remove the mounting sleeve from the main unit (see
"Removal" on page 26).
This unit
Screws (M5 x
8)
(InclUded)
2
Screw
Hex Nut (M5)
Metal
Mounting
Strap
Chassis
SecLlre the groLllld lead of the L1llilto a c1eallllleltll spot L1Sillg a screw
(,.3) already aI/ached to the vehicle's chassis.
26-EN