Electronics Car Stereo System User's Manual

7-EN
3 Press RESET with a ballpoint pen or similar pointed
object.
Adjusting Volume
Turn the Rotary encoder until the desired sound is
obtained.
Lowering Volume Quickly
Activating the Audio Mute function will instantly lower the volume
level by 20 dB.
Press MUTE to activate the MUTE mode.
The audio level will decrease by about 20 dB.
Pressing MUTE again will bring the audio back to its
previous level.
Setting the Time and Calendar
1 Press and hold F/SETUP for at least 2 seconds to
activate the SETUP selection mode
.
2 Turn the Rotary encoder to select the General
mode, and then press
/ENT.
Bluetooth* General Display Tuner Bluetooth
* Displayed only when INT Mute is OFF, and the mode is set to other
than Bluetooth Audio.
3 Turn the Rotary encoder to select Clock Adjust,
and then press
/ENT.
4 Turn the Rotary encoder to set year.
5 Press /ENT.
6 Repeat steps 4 and 5 above to set month, day, hour
and minute.
7 Press and hold F/SETUP for at least 2 seconds to
return to normal mode.
• Pressing /ESC returns to the previous SETUP mode.
• If no operation is performed for 60 seconds, SETUP is cancelled.
• To synchronise the clock to another clock/watch or radio time
announcement, press and hold
/ENT for at least 2 seconds after
setting the “hour”. Minutes will reset to 00. If the display shows over
“30” minutes when you do this, the time will advance one hour.
Listening to Radio
1 Press SOURCE/ to select the TUNER mode.
2 Press BAND/TA repeatedly until the desired radio
band is displayed.
FM1 FM2 FM3 MW LW FM1
3 Press TUNE/A.ME to select the tuning mode.
DX (Distance mode) LOCAL (Local mode)
MANUAL (Manual mode) DX
• The initial mode is Distance mode.
Distance mode:
Both strong and weak stations will be automatically tuned in
(Automatic Seek Tuning).
Local mode:
Only strong stations will be automatically tuned in (Automatic
Seek Tuning).
Manual mode:
The frequency is manually tuned in steps (Manual tuning).
4 Press or to tune in the desired station.
Holding down or will change the frequency
continuously.
Presetting Stations Manually
1 Select the radio band and tune in a desired radio
station you wish to store in the preset memory.
2 Press and hold, for at least 2 seconds, any one of the
preset buttons (1 through 6) into which you wish
to store the station.
The selected station is stored.
The display shows the band, preset number and station
frequency memorized.
• A total of 30 stations can be stored in the preset memory (6 stations
for each band; FM1, FM2, FM3, MW and LW).
• If you store a station in a preset memory which already has a station,
the current station will be cleared and replaced with the new station.
• If the function mode is activated, press F/SETUP to return to preset
mode.
RESET switch
Radio
BAND/TA
//
TUNE/A.ME
Rotary encoder
/ENT
Preset buttons
(1 through 6)
/ESC
F/SETUP
SOURCE/