Owner`s manual

41-EN
Other Useful Features
Automatic Time Adjustment
Time can be automatically adjusted via RDS.
1 Press and hold MUTE/SETUP for at least 2
seconds.
2 Press preset 2 to select GENERAL setting
mode. Press preset 2 again to select RDS
CLOCK.
3 Press g or f to select ON or OFF.
4 When the setting is completed, press MUTE/
SETUP to return to normal mode.
Setting the External Expansion
Box
When using the optional expansion box (KCE-
104V), you can use this function.
1 When the monitor is open, press and hold
MUTE/SETUP for at least 2 seconds. The
SETUP screen appears.
2 Press preset 5 to activate the SYSTEM setting
mode. Press preset 5 again to select EXPAND
BOX.
3 Press g or f to set KCE-104V/OFF.
KCE-104V: When connecting the expansion
box KCE-104V (not supplied).
OFF: When not connecting the expansion
box KCE-104V (not supplied).
(Make sure that KCE-104V is selected when the
KCE-104V is connected.)
For any other settings, press preset 5 or another
preset button.
4 After setting is completed, press MUTE/SETUP
to return to normal mode.
NOTE
The CVA-1004R is not compatible with the KCE-103V.
Rear Monitor Setting
The optional expansion box (KCE-104V) must be
connected. If AUX/NAV. is turned ON (as shown in
“Setting the External Input” on page 42), and a
rear-seat monitor and navigation system are
connected to the CVA-1004R, the picture/sound
for the rear-seat monitor can be selected from the
CVA-1004R.
1 When the monitor is open, press and hold
MUTE/SETUP for at least 2 seconds. The
SETUP screen appears.
2 Press preset 3 to activate the AUX setting mode.
Press preset 3 again to select MONITOR-1
OUT/MONITOR-2 OUT.
3 Press g or f to select the mode to display
on the rear monitor.
AUX-1/AUX-2/AUX-3
∗
:
The picture/sound of the device connected to
Terminal AUX will be played on the rear-seat
monitor.
∗ AUX NAME set in the “Setting the External Input”
(page 42) will be displayed.
NAV. :
The navigation screen will be displayed on the
rear-seat monitor and the voice guidance will
be produced if the navigation system is
connected.
SPE.ANA :
The SPE.ANA image is displayed when set to
ON in “Displaying Spectrum Analyzer” (page
43).
OFF :
AUX OUT mode is cancelled.
For any other settings, press preset 3 or another
preset button.
4 After setting is completed, press MUTE/SETUP
to return to normal mode.
NOTE
If a DVD player or DVD changer is connected to the
AUX 1, AUX 2 or AUX 3 terminal, the DVD picture
appears by performing steps 1 and 2 of "Simultaneous
Operation" on page 46. Then, perform steps 1 to 4 on
this page so the DVD picture and sound are output.