Owner`s manual

17-EN
Memorizing the Ensemble
Automatically
1 Press BAND/TEL. to select the band that you
want to receive.
2 Press and hold TUNE/A.ME for at least 2
seconds.
The ensemble is searched for, and six
ensembles are automatically received and
memorized with the preset buttons (1 through 6).
When memorization has completed, the
Ensemble that was memorized last is received.
By selecting the mode in the “Changing the
Display Mode” section (see page 19), the display
shows the status of the broadcasting stations
that have been received as follows:
Channel No. Display:
The channel numbers of received stations are
displayed.
Ensemble Label Display:
The Ensemble Label of received station is
displayed.
Service Label Display:
The Ensemble Label is displayed for 2 seconds
and then the Service Label is displayed after
receiving the broadcasting station.
Component Label Display:
The Ensemble Label is displayed for 2 seconds,
then the Service Label is displayed for 2
seconds, and then the display is changed to the
Component Label after receiving the
broadcasting station.
Dynamic Label Display:
The Ensemble Label is displayed for 2 seconds,
then the Service Label is displayed for 2
seconds, and then the display is changed to the
Dynamic Label after receiving the broadcasting
station.
NOTE
If no ensemble is received, the one that has been received
before you perform this automatic memorization is
received.
DAB Operation (Optional)
PTY (Programme Type) Tuning
1 Press FUNC and the “FUNC” indicator lights.
2 During radio (DAB receiving) mode, press
2/PTY to go to the PTY Select mode.
3 Press g or f to select your desired
programme type.
4 After selecting a programme type, and when the
“FUNC” indicator is lit, press 2/PTY to go to the
PTY Search mode.
The selected programme type is searched for.
NOTE
To cancel the PTY Search mode and return to the PTY
select mode during the PTY search, press 2/PTY, g or
f.
5 When the station is received, the received
programme type is displayed for 5 seconds. If no
station is found, “NO PTY” is displayed for 2
seconds.
NOTE
Above functions can be performed only for services
within an ensemble.
Turning ON/OFF Traffic News
Announcement
When you set to ON, you can automatically
receive the Traffic News.
1 Press T.INFO/ANNC to set ON/OFF for the
Traffic News.
NOTES
• You can also set the RDS stations at the same time.
• This operation can also be performed by turning the
Traffic News ON/OFF in the “Setting the
Announcement Select Mode” section on page 18.