Owner`s manual

12-EN
RDS Operation
Receiving RDS Regional (Local)
Stations
1 When the monitor is open, press and hold
MUTE/SETUP for at least 2 seconds. The
SETUP screen appears.
2 Press preset 4 to activate the RADIO setting
mode. Press preset 4 again to select
REGIONAL.
3 Press g or f to turn to OFF or ON the
REGIONAL mode.
In the REGIONAL OFF mode, the unit
automatically keeps receiving the related local
RDS station.
For any other settings, press preset 4 or another
preset button.
4 After setting is completed, press MUTE/SETUP
to return to normal mode.
PI SEEK Setting
1 When the monitor is open, press and hold
MUTE/SETUP for at least 2 seconds. The
SETUP screen appears.
2 Press preset 4 to activate the RADIO setting
mode. Press preset 4 again to select PI SEEK.
3 Press g or f to set PI SEEK to ON/OFF.
For any other settings, press preset 4 or another
preset button.
4 After setting is completed, press MUTE/SETUP
to return to normal mode.
Receiving Traffic Information
1 Press T.INFO/ANNC. to activate the Traffic
Information mode.
2 Press g or f to select your desired traffic
information station. When a traffic information
station is tuned in, the TP indicator lights up.
Traffic information is heard only when it is being
broadcast. If traffic information is not being
broadcast, the unit is set in the standby mode.
When a traffic information broadcast begins, the
unit automatically receives it and the monitor
shows “T.INFO” during the traffic information
broadcast (sub-display shows "TRF-INFO" for 2
seconds, then returns to the previous display.)
When traffic information broadcast is over, the
unit will automatically set in the standby mode.
3 Press T.INFO/ANNC. to activate the normal
mode.
NOTES
• If the traffic information broadcast signal falls below a
certain level, the unit remains in the receiving mode
for 1 minute. If the signal remains below a certain
level for over 1 minute, the "T.INFO" indicator blinks.
• If you do not want to listen to the traffic information
being received, lightly press T.INFO/ANNC. to skip
that traffic information message. The T.INFO mode
will remain in the ON position to receive the next
traffic information message.
• If the volume level is changed while receiving traffic
information, the changed volume level will be
memorized. When traffic information is received next
time, the volume level will be automatically adjusted
to the level memorized.
• In the T.INFO mode, the SEEK tuning selects only the
TP stations.
gg
gg
g
ff
ff
f FUNCPreset 4
MUTE/SETUP
T.INFO/
ANNC.
2/PTY