Instructions / Assembly

3
Installation Instructions
• One wall stud MUST be located and USED for at least one side of the diaper changing station.
• The diaper changing station CANNOT be heavier than the anchors or walls they are attached to.
• It MUST be firmly secured to support the additional weight of a child.
• Contact an architect or building contractor for further questions.
STEP 1:
A. Locate the wood stud where the left side of Changing Station (1) will be mounted to the wall.
STEP 2:
A. Measure up 42’’ (107cm) from the floor and mark the wall; this locates the top left attachment hole’s
position.
NOTE: Mark on wall MUST be in the center of the wood stud.
STEP 3:
A. Align the hole in the top left corner of Changing Station (1) with the mark on the wall and hold it in
place.
STEP 4:
A. Using a level and measuring tape, mark the remaining three (3) holes.
B. After marking holes, set the Changing Station (1) down on the ground.
STEP 5:
A. Use a power drill and appropriate bit to drill four (4) holes in the wall.
B. This may require two (2) people.
NOTE 1: FOR WOOD STUDS:
• If the finished wall surface is tile or masonry over wood studs, use a 7/32” masonry bit for the pilot hole
until you hit the wood stud, then change it to a 1/8” bit.
• Use Wood Screws (A), finishing Washers (B), and Flat Washers (D) (See Figure A on page 4).
WARNING:
!