Installation Guide

ManualsBrandsAlpine Electronics ManualsGPS Navigation SystemsX109-WRA

1

2

3

4

5

6

7

8

9

Jeep Wrangler

WRANGLER  9/15

Installation Instructions

2 Remove the vents from the radio section on the

OEM dash panel by pressing down on the lock tab

and turning right. Mount vents on to the X109-WRA

bezel.

Lock tab

Rear view

4 Mount the microphone as illustrated and run the

cable to the radio cavity.

6 Attach the Maestro to the main harness.

1 The factory dash panel needs to be trimmed to

allow the new X109-WRA bezel to ﬁt into place.

Remove the highlighted area by cutting along the

dashed line.

3 Use a cutting tool to trim the highlighted area

shown below.

5 Plug the OBDII connector on to the OBDII port

below the driver side dash and run the extension to

the radio cavity.