Installation Guide

Chevrolet/GMC
FULL SIZE TRUCK  7/13
1 Remove the fuse panel cover.
2 Extract 2x Phillips screws, 1x 10mm bolt from the
drivers side knee cover and unsnap it
3 Extract 2x 9/32” - 7mm screws from the middle
panel and unsnap it.
4 Extract 2x Phillips screws from instrument panel
cover and remove it. Remove the radio bezel by
unsnapping it.
5 Extract 6x 7/32” - 7mm screws from the factory
radio/HVAC assembly and remove it.
6 Use a cutting tool to trim out the highlighted area as
shown below.
Factory Radio Removal Process