Installation Guide

Chevrolet/GMC
FULL SIZE TRUCK & SUV  8/20
X009-GM System Wiring for 2012-14 Navigation Equipped Vehicles
To retain a pre-existing factory rearview camera
• Locate the 20-pin radio plug , connect the PINK or WHITE wire located at pin 5 to the center of yellow conductor of a yellow RCA, connect
the LIGHT BLUE or BARE wire located at pin15 to the shield of the yellow RCA.
X009 Head Unit
To X009-GM
Key Panel
Main Harness
Chime Speaker
X009 Camera
Harness
Camera Input Back-up
Camera In
HDMI Input
USB Extension
Cable
To SXM
Aux/Pre-out
Harness
GPS Antenna
Subwoofer
10-pin Green
Connector
3.5 mm Mini plug
10-pin Black
Connector
4-pin Black
Connector
18-pin Black
Connector
To Overhead
Screen
Center Out
Sub Out
Aux Output
PurpleRed
GreenWhite
GrayRed
WhiteWhite
Aux Input
Front
Rear
Front Rear A/V
Input
3-pin Black
Connector
4-pin Data
Connector
Blue Power Antenna
(Not used)
Green/
White
Blue/White Amp Turn-on
3.5 Mini plug
Speed Pulse
4-pin Data Connector
To ODB II
Connector
iDatalink MAESTRO Module
To Vehicle Connectors
Use PAC GMRVD2
or equivalent
Navigation
Adapter
Vehicle Camera
Harness
Use only with aftermarket
amplifiers
Connect if factory-equipped using
RCA Y-cable to front RCA outputs
Connect if factory-equipped
X009
Power
Harness
If Bose is equipped,
connect Bose
adapter harness on
vehicle side.