User manual

90-EN
System Example
Connect the Ai-NET compatible audio processor (Fiber optic digital compatible), Navigation system, DVD player and
changer.
• When the fiber optic digital compatible product is connected, it is necessary to set the mode of this unit. Refer to “Setting the Digital Output”
(page 46).
Please observe the following when using Fiber optic Cable.
• Do not coil the Fiber optic Cable smaller than a 30 mm radius.
• Do not place anything on top of the Fiber optic Cable.
• Be careful not to bend the Fiber optic Cable at a sharp angle.
Navigation system
(Sold Separately)
Fiber optic digital Input
terminal (for head unit)
Audio Processor (Ai-NET)
(Fiber optic digital
compatible) (Sold Separately)
Fiber optic
digital Input
terminal (for
DVD Player)
Ai-NET
cable
Fiber optic
digital Input
terminal (for
Changer)
*Fiber optic
cable
Ai-NET
cable
CD Changer (Ai-NET)
(Sold Separately)
*Only connect Fiber optic digital compatible CD Changer
DVD Video Player
(Ai-NET)
(DVA-5210 etc.)
(Sold Separately)
Fiber optic cable
REMOTE IN
REMOTE OUT
(White/Brown)
(White/Brown)
(Yellow)
Ai-NET cable
(Yellow)
Optical Digital Cable (KWE-610A)
NVE-N099P, etc.
System Switch
When connecting an equalizer or divider using Ai-NET
feature, place the two switches in the EQ/DIV position.
When no device is connected, leave the switch in the
NORM position.
Change both switches to the left to set to the NORM
position.
Change both switches to the right to set to the EQ/DIV
position.
(If the front panel is viewed from the front.)
• Do not make the two switches to different settings.
• Be sure to turn the power off to the unit before changing the switch
position.
Optical Digital Cable (KWE-610A) (Sold Separately)
RGB Input Connector (Black)
Connect this to the RGB output terminal of the Navigation
System.
RGB Cable (Included with Navigation)
Ai-NET Connector
Connect this to the output or input connector of other
product equipped with Ai-NET.
Ai-NET Cable (Included with DVD video player)
Video Input/Camera Input RCA Connector
(AUX/CAMERA IN) (Yellow)
Input the AUX video or use when connecting a rearview
camera with RCA Output connector.
• When you use this connector as normal AUX video input connector,
set other than “AUX” in “Setting the Rear Camera Input” (page 44),
and set “AUX1 IN” to ON in “Setting the AUX Mode”.
RCA Extension Cable (Included with DVD video
player)
Fiber optic Cable (Sold Separately)
Ai-NET Cable (Included with Audio Processor)
Ai-NET Cable (Included with CD Changer)
Remote Control Output Lead (White/Brown)
Connect this lead to the remote control input lead. This lead
outputs the controlling signals from the remote control.
To Ai-NET Connector (Grey)
To Ai-NET Connector (Black)
Digital Output Terminal (Optical)