User manual

80-EN
MP3/WMA/AAC is not played back.
• Writing error occurred. The CD format is not compatible.
- Make sure the CD has been written in a supported format.
Refer to
“About MP3/WMA/AAC” (pages 19 and 20), then
rewrite in the format supported by this device.
Unit does not operate.
• Monitor’s power is not turned on.
- Turn on the monitor’s power.
• Condensation.
- Wait a while (about 1 hour) for the condensation to dry.
No picture is produced.
• Monitor’s mode is not switched to the mode you want to see.
- Switch to the mode you want to see.
• Monitor’s parking brake lead is not connected.
- Connect the monitor’s parking brake wire and set the parking
brake.
(For details, refer to the monitor’s instructions.)
Playback does not start.
• Disc is loaded upside-down.
- Check the disc and load it with the labelled side facing upward.
•Disc is dirty.
- Clean the disc.
• A disc not able to play back with this unit is loaded.
- Check if the disc is able to be played back.
• Parental lock is set.
- Cancel the parental lock or change the rating level.
Picture is unclear or noisy.
• Disc is being fast-forwarded or fast-reversed.
- The picture may be slightly disturbed, but this is normal.
• Vehicle’s battery power is weak.
- Check the battery power and wiring.
(The unit may malfunction if the battery power is under 11
volts with a load applied.)
• Monitor’s fluorescent tube is worn.
- Replace the monitor’s fluorescent tube.
Image stops sometimes.
• Disc is scratched.
- Replaced with a non-scratched disc.
Playing back a DRM protected DivX File
Some operations cannot be performed while displaying the
following message.
“Authorization Error This player is not authorized to play
this video.”
• If an unauthorized DRM protected DivX
®
file is played back,
the following message is displayed for 2 seconds:
“Authorization Error This player is not authorized to play this
video”. This means the file’s registration code does not match
the player’s and cannot be played back. After the message has
been displayed, the beginning of the next file will automatically
begin playing.
“Rental expired”
•A DivX
®
rental is set for a fixed number of viewings. If viewing
time has counted down to 0, “Rental expired” is displayed for 2
seconds. This indicates that the file can no longer be played.
After the message has been displayed, the beginning of the next
file will automatically begin playing.
“Rental Countdown OK?”
• While playing back a rental file, if B.SKIP or ENTER is selected
in the file selection menu, “Rental Countdown OK?” is
displayed. The rental file playback is interrupted (viewing time
is reduced by 1). To confirm stopping playback, touch [Yes], or
touch [No] to continue playing the file.
“View DivX
®
VOD Rental
This rental has (remaining times) views left.
Do you want to use one of your (remaining times) views
now?”
• If audio/visual times still remain, the remaining number of
playback times is displayed. To play back, touch [Yes]. If the
next file is to be played back, touch [No].
Indication for CD/MP3/WMA/AAC
• No disc is inserted.
- Insert a disc.
• Although a disc is inserted, “No Disc” is displayed and the unit
does not start to play or eject the disc.
- Remove the disc by following these steps:
Press for at least 3 seconds.
• Mechanism error.
1) Press and eject the disc.
If not ejecting, consult your Alpine dealer.
2) When the error indication remains after ejecting, press
again.
If the error indication still does not turn off after pressing
for a few times, consult your Alpine dealer.
• Scratched disc, contaminated disc/poor recording/disc
incompatible with this unit.
- Press .
- Change the disc.
• A copy-protected WMA file was played back.
- You can only play back non-copy-protected files.
• A sampling rate/bit rate not supported by the unit is used.
- Use a sampling rate/bit rate that is supported by the unit.
®