User manual

20-EN
Adjusting the Screen Viewing Angle
Adjust the screen’s angle for better visibility.
1 Press c (Eject).
The Open/Tilt screen is displayed.
2 Touch [Up] or [Down] of “Tilt” to adjust the
desired screen angle.
The screen angle can be adjusted in 5 stages.
3 Touch [] to return to the normal mode.
• The screen colour will vary when viewed at certain angles. Adjust the
screen angle for the best viewing position.
• If the voltage of the vehicle’s battery power is low, the screen may
blink when the screen angle is changed. This is normal and not a
malfunction.
Detaching and Attaching the Screen
It may be difficult to remove the screen panel in some angle, so please
select a proper angle to detach the screen panel easily base on your
vehicle type and the installation location of the main unit. Refer to
“Setting the Remove Screen Angle” on page 42. And please according
to the following operation to remove the screen panel.
1 Press c (Eject).
The Open/Tilt screen is displayed.
2 Touch [ Remove Screen].
A confirmation message is displayed.
3 Touch [OK] to confirm.
Touch [Cancel] will return to normal mode.
The screen turns to the Remove Screen Angle which is set
in “Setting the Remove Screen Angle” (page 42). Then, a
count down for 30 seconds is displayed.
• If you do not want to remove the screen panel, press
c (Eject)
button to return to normal mode.
• If the Screen is not detached within 30 seconds, the unit will
return to normal mode.
4 Press the Release Lever on the bottom of the screen
panel (figure1) within the 30 seconds count down.
The screen panel is unlocked (figure2).
• After the Release Lever is pressed, the front panel will close in
15 seconds, whether the screen panel is detached or not.
5 Grasp the screen panel firmly, and force the bottom
of the screen panel outward to make it depart from
the main unit.
• When the screen panel is detached, please keep your hand away from
the unit, because the front panel will close automatically in 15
seconds after the Release Lever is pressed.
• The screen panel may become hot in normal usage (especially the
connector terminals on the back of the screen panel). This is not a
malfunction.
• To protect the screen panel, place it in the supplied carrying bag.
• When detaching the screen panel, do not apply excessive force as it
may result in malfunction.
• If Auto Open/Close is set to On, the screen will turn to the Remove
Screen Angle automatically when ignition is set to OFF. Refer to
“Opening/Closing Screen Automatically” on page 42.
Detaching
figure2
figure1
figure3