User manual

39-EN
Presetting Stations Automatically
The tuner can automatically seek and store 12 strong
stations in the selected band in ascending order of
frequency.
Select the desired band then touch and hold
[Auto Memory].
The tuner automatically seeks and stores 12 strong stations
into the preset list in ascending order of frequency.
When automatic storing has completed, the station stored
in the preset 1 is selected.
• If no stations are stored, the tuner will return to the original
station you were listening to before the automatic storing
procedure began.
• You can cancel this process by touching [Auto Memory] while
the tuner is automatically seeking stations. Canceling will
return the tuner preset to the previous setting.
Tuning to Preset Station
After selecting the desired band, touch the
desired preset button.
The preset station is received.
RDS Operation
Turning AF (Alternative Frequencies)
On or Off
The RDS (Radio Data System) is a radio information system
using the 57 kHz subcarrier of regular FM broadcasts. The
RDS allows you to receive a variety of information such as
traffic information, station names, and to automatically
re-tune to a stronger transmitter that is broadcasting the
same programme.
• Set RDS Alternative Frequency to [On] in “Turning AF
(Alternative Frequencies) On or Off ” (page 19).
• RDS mode is not be displayed for the AM band.
• When the AF ON mode is selected, the unit automatically
tunes to a strong signal station in the AF list.
• Use the AF OFF mode when automatic re-tuning is not
required.
Tips
• The RDS digital data includes the following:
PI Programme Identification
PS Programme Service Name
AF List of Alternative Frequencies
TP Traffic Programme
TA Traffic Announcement
PTY Programme Type
EON Enhanced Other Networks
• Refer to page 19 about “PI SEEK Setting,” “Setting the RDS
Regional Mode,” and “Setting the PTY31/Alarm Interrupt.”
Interruption Function
Interruption Function is enabled, when the following
broadcast is received, the unit switches to the Radio source
screen automatically, and will receive broadcasts.
– Alarm (Emergency Broadcast)*1, 4
– TA(Traffic Announcement)*2, 5
– News Announcement*3, 4
*1 Set PTY31/Alarm Interrupt to [On] in “Setting the PTY31/
Alarm Interrupt” (page 18).
*2 Set TA/Traffic Interrupt to [On] in “Setting the TA/Traffic
Interrupt” (page 18).
*3 Set News Interrupt to [On] in “Setting the News
Interrupt” (page 18).
*4 Not interrupted during the DAB broadcast reception.
*5 The Interruption Function for Traffic Announcements
works with DAB broadcasts. Therefore, even if the current
source is RDS, a Traffic Announcement by DAB broadcast
may interrupt.
• “RDS Alarm”/”RDS T.Info”/”RDS News” is displayed in the
Band display section during each respective broadcast
reception.
• To cancel the Interruption function, touch [Cancel].