User manual

41-EN
[System] is selected on the Setup main screen in step 3. See “Setup
Operation” (page 24).
System Setup Menu screen
<Setting items>
*1 When Camera Select is set to “Off,” you cannot select this item.
*2 CAN-I/F BOX should be connected before this operation.
*3 Set this setting after closing the Alpine TuneIt App.
1 Select the desired item.
2 To switch the setting, touch [], [], [], [], or mark the
checkboxes “Off” ( ) or “On” ( ).
• If “ ” appears, there is a further hierarchy. Touch the desired
item.
3 To uc h [] to return to the main source screen.
• To return to the previous List screen, touch [] or [] in the
previous page. For details, see “About Basic Operation for List
Screen” (page 14).
Camera Setup
[Camera] is selected on the System Setup Menu screen in step 1. See
“System Setup” (page 41).
You can set up items related to the Camera.
Setting item:
Camera Select
Setting contents:
Off (Initial setting) / Rear
When the camera is connected, the video input signal type can be
chosen.
Further setting item:
Camera Signal
Setting contents:
NTSC (Initial setting) / PAL
You can adjust the camera guide position.
Setting item:
Guide Adjustment
1 To uc h [Guide Adjustment].
The camera guide adjustment screen is displayed.
2 To uc h [Adjust].
•If [Adjust] does not appear, proceed to step 3.
3 Touch the guide you intend to adjust.
Guide line can also be selected by touching [] [].
System Setup
Camera
Camera Select
Camera Signal*
1
Guide Adjustment*
1
Interrupt (Power OFF)*
1
CAN-I/F*
2
Default Vehicle Screen
Climate screen interrupt time
Parking sensor interrupt
Unit
External AP
Application
Alpine TuneIt App*
3
The following steps 1 to 3 are common to each “Setting
item” of System Setup. See each section for details.
Setting the Camera Input
Off: No camera is connected
Rear: Rear camera is connected
Setting the Camera Signal Input
Adjusting the Rear Camera Guide