Full Product Manual

Assembling & Using Your Product
Unpack all components carefully. Please check to ensure all parts have been
removed from the packaging. Some splashing may occur.
Components:
 Fountain
 Submersible Pump Kit
 Topper Cover
 LED Light
 Bird
1 2 3
Assembling:
 Place fountain on a dry leveled surface.
 Remove topper cover and attach bird on the hole found on the fountain,
see diagram 1 above.
 Connect the vinyl tubing to the water pump found inside the fountain.
Adjust the flow control to the lowest setting to avoid splashing until the
fountain is completely assembled. Make sure the light is placed on the
topper cover hole, see above diagram 2.
 Connect the LED light strand to the pump. The pump cord needs to go
through the tube found inside the fountain and going out through the
back, as shown on diagram 2.
 Place the topper cover back.
 Gently pour water into the fountain, being careful not to overflow and
cause splashing. Make sure the water completely submerges the pump
and the water runs clear during operation. Plug the pump cord into your
local power supply. Make sure that there is no water around the
electrical outlet and always keep the power source in a dry place.
o NOTE: We recommend that you use distilled water to prevent
scale build-up. The first time you operate the pump it can take
up to 5 minutes for the air to be completely expelled and water
begins to flow properly.
Trouble Shooting & Caution
If you have any questions and/or problems, please contact the retail store you
purchased this fountain.
 If your pump fails to run
 Check the circuit breaker or try a different outlet to make sure the pump is
receiving electrical power.
 Check the pump discharge and tubing for any kinks and/or obstructions
 Any buildup obstructing the water flow can be flushed with a garden hose
 Check the rotor by removing the front cover & plate to access the impellor area.
Turn the rotor and make sure that the rotor is not jammed or broken
 If your pump “spews”
 Check the water level to make sure the pump is completely submerged and
there if enough water in the basin to operate your fountain. Not having enough
water will cause your pump to spew
 If your pump is making abnormal loud noises
 Disconnect the pump from the electrical power supply and remove the front
cover & plate
 Carefully grip the impeller and gently pull the impeller/rotor assembly out of the
pump housing
 Rinse the impeller/rotor assembly and clean the cavity with clean water. If
breakage or damage is found, contact your local retailer for part
 Fountain Care
 We recommend to use Alpine’s all natural cleansing formula to eliminate foam,
lime scale and calcium buildup, fight mineral deposits, leave water crystal clear,
help prevent staining, remove organic contaminants and treat discolored water.
This formula will help prevent pump damage due to hard water build up.
i. For small sized fountains holding water up to 7liters of water, we
recommend Alpine Item # PPL100
ii. For larger sized fountains holding water over 7liters of water, we
recommend Alpine Item # PPL102
iii. For more information please visit www.alpine4u.com
 Caution
o Always unplug the pump from the electrical outlet before
cleaning & handling
o Uses with clean water only, do not place the fountain and/or
parts in any other liquid.
o Periodically change water & clean the pump to keep free
from micro-organisms
o Disconnect and store the unit in a dry place if not in use for
an extended period of time
o Do not operate with water above 90°F or 30°C
o Do not lift, carry or pull the pump by the power cord
o Do not exceed the maximum voltage & wattage on
transformer
o NEVER LET THE PUMP RUN DRY