, OWNER S MANUAL AIR CONDITIONER ACI/AOU-35HPR1 ACI/AOU-53HPR1 ACI/AOU-71HPR1 ACI/AOU-105HPS3 ACI/AOU-140HPS3 AFI/AOU-53HPR1 AFI/AOU-105HPS3 AFI/AOU-140HPS3 AFI/AOU-180HPS3 ATI/AOU-53HPR1 ATI/AOU-105HPS3 ATI/AOU-140HPS3 Thank you very much for purchasing our air conditioner, please read this owner's manual carefully before using your air conditioner.
IMPORTANT SAFETY INFORMATION Danger ! CAUTION Do not attempt to install this unit by yourself. This unit requires installation by qualified persons. ! DANGER Do not attempt to service the unit yourself. This unit has no user serviceable components. Opening or removing the cover will expose you to dangerous voltage. Tuning off the power supply will not prevent potential electric shock. ! DANGER Never put hands or objects into the Air Outlet of indoor or outdoor units.
HINTS FOR ECONOMICAL OPERATION The following should be noticed to ensure an economical operation. (Refer to corresponding chapter for details) Adjust the air flow direction properly to avoid winding toward your body. Adjust the room temperature properly to get a comfortable situation and to avoid supercooling and superheat. In cooling, close the curtains to avoid direct sunlight. To keep cool or warm air in the room, never open doors or windows more often than necessary.
Ceiling & Floor Type (for VERTICAL DISCHARGE AIR CONDITIONER) l m J g n i e a o f k Display Panel p h d d b p b or d C p c NOTICE! The chart based on one model of our product is for reference only, which may be different from the unit you purchased. NAMES AND FUNCTIONS a indoor unit d g i installation part j FAN/DEF indicator (For cooling and heating type, its D EF.
Ceiling & Floor Type g q i J n k l m o e a f Display Panel p h d d b p b or d C p c NOTICE! The chart based on one model of our product is for reference only, which may be different from the unit you purchased. NAMES AND FUNCTIONS a indoor unit d g i installation part j FAN/DEF indicator (For cooling and heating type, its D EF.
Ceiling & Floor Type i a k g e f n o j m l Display Panel p h d d b p b or d C p c NOTICE! The chart based on one model of our product is for reference only, which may be different from the unit you purchased. NAMES AND FUNCTIONS a indoor unit d g i installation part j FAN/DEF indicator (For cooling and heating type, its D EF.
TEMPORARY OPERATIONS This function is used to operate the unit temporarily in case you misplace the remote controller or its batteries are exhausted. Two modes including AUTO and mandatory COOL can be selected through the TEMPORARY BUTTON on the air inlet grill control box of the indoor unit. Once you push this button, the air conditioner will run in such order: AUTO, mandatory COOL, OFF, and back to AUTO. TEMPORARY BUTTON 1.
Duct and Ceiling Type 1. Open the air-in grill Push the grill switches towards the middle simultaneously as indicated in follow figure sketch. Then pull down the air-in grill. Cautions: The control box cables ,which are originally connected with the main body electrical terminators must be pulled off before doing as indicated above. Clip Open< 2. Take out the air-in grill. 3. Dismantle the air filter 4. Clean the air filter (Vacuum cleaner or pure water may be used to clean the air filter.
Air conditioner operating conditions For proper performance, run the air conditioner under the following temperature conditions: Outdoor temperature: 21 to 43oC Room temperature: 17 to 32oC Cooling operation Heating operating (cooling only type without) Dry operation CAUTION Room relative humidity less than 80%. If the air conditioner operates in excess of this figure, the surface of the air conditioner may attract condensation.
TROUBLES AND CAUSES Before you ask for servicing or repairs, check the following points. Recheck Inoperative The power fuse is blown or the circuit breaker has been tripped. The batteries in the remote controller are exhausted. The timer is set. Does not cool or heat well. The air inlet or outlet of the outdoor unit is blocked. Doors or windows are open. The air filter is clogged with dust. The louver is not at the correct position. The fan speed is set to low.
The Transmission Indicator " " Never Comes On Symptoms Reason and Disposal Causes The remote control signal is not transmitted even when the ON/OFF button is pushed. Check whether the batteries in the remote controller are exhausted. The remote control signal is not transmitted, because the power supply is off. The Display Never Comes On Symptoms Reason Causes Check whether the MODE indicated on the display is "FAN ONLY". FAN ONLY The TEMP. indicator does not come on.
