User manual

10|Page
The light sensitivity trimmer allows you to set the level of light that triggers when the LED
lights come on. These lights shed additional lighting so that the camera will work at night.
The light sensitive sensor is only active during the call and automatically switches off at the
end.
DIP relay setting of base parameters and mode with DIP relay
Reserve
1. Change of mode P2P/SIP server
2. Basic setting – deletes all parameters and changes them
to factory setting (apart from number memory)
3. Sets basic IP address to 192.168.1.250
Changes will take effect after restart. DIP relays 3 and 4 must
always be switched to the “on” position after the restart,
otherwise the new parameters or IP address will be lost and the unit will automatically revert
to the standard factory settings.
1.5 Door Entry system assembly
1.5.1 Front-cover Assembly and Disassembly
Picture 6