Installation guide

IPDP - installation and operating instructions
19
set point, then the DoorPhone will pick up and close the corresponding switch
(if set in m=1 or m=5 modes) to the period given by seting in parameters. Then
it will hang up.
2.2.2 DoorPhone with Keyboard
The DoorPhone with keyboard can also include besides
the keyboard up to 16 buttons of direct dialing always
behaving as to be mentioned in 1.4.7(page 16) except the
code lock. This one is always situated on keyboard. After
keyboard is connected, the position, where the keyboard is
connected to, should be set in programming parameter.
The keyboard has two functional buttons – B symbol =
once pressing the numerical combination is considered as the combination for
control of the switches. The second button – A symbol = when pressing the
DoorPhone immediately will hang up.
The number selection on keyboard can be executed in two ways:
- The incoming person is dialing number as to be done on phone – the
period among button presses should be lower than the value given
by programming parameter. After this period the DoorPhone will lift
up and dial the given number.
- On buttons the incoming person is dialing a two-digit number (from
01 to 64), which represents the memory number, where the 16-digit
number is stored (same as for buttons). The number dialing is
managed by Day/Night setting or mode for two groups of numbers
(as described in chapter 2.2.1 page 18).