User manual

B EAMER
Beaming from One NEO to Another from Within the Beamer SmartApplet
8-4
. . . . .
User Manual
7. Make sure the receiving device is turned on, that it is within three feet of
the beaming device, that it is ready to receive, and that both devices have
their infrared ports pointing at each other.
8. Press send on the sending NEO to start beaming the file.
Steps to Follow on the Receiving Device (If It Is a NEO):
1. Turn on the NEO by pressing on/off.
2. Press applets to view the SmartApplets menu.
3. Use the arrow keys to move the cursor next to Beamer in the list; then,
press enter. The Beamer screen appears.
4. Move the cursor next to Receive and press enter.
5. If there is data on the clipboard, the following screen appears:
If there’s no data on the clipboard, or if NEO hasn’t been set to warn
about overwriting the clipboard (see “Beamer and the NEO Clipboard” on
page 8-6), the following screen appears:
Select a Beaming function:
- Send
- Receive
- Settings
There is data currently on the
clipboard. Press the enter key to
overwrite the data.
(Press esc key to cancel)
Ready to receive a file.
(Press esc key to cancel)