Data Sheet

Product Specification Sheet APS1021 - Rev. 05/2017
WES555 Emergency Pull/Push Station (AlphaEcall™ 200 series)WES555 Emergency Pull/Push Station (AlphaEcall™ 200 series)
42 Central Drive • Farmingdale • NY • 11735-1202 • Phone: [phone] • Fax: [phone] Central Drive • Farmingdale • NY • 11735-1202 • Phone: [phone] • Fax: [phone]
TOLL-FREE: [phone] • Web: AlphaCommunications.com • Email: [e-mail]-FREE: [phone] • Web: AlphaCommunications.com • Email: [e-mail]
Copyright© 1998-2017 Alpha Communications® - All Rights Reserved.
Due to continuous product improvement, all colors, sizes, materials, finishes and specifications are subject to change without notice.
Architects' And Engineers' SpecificationsArchitects' And Engineers' Specifications
The Wireless Emergency Push/Pull Stations shall be shall be Alpha
Communications® AlphaEcall™ 200 series model WES555, or
approved equal. Operation of emergency signals shall be
accomplished by a short pull on the nylon cord or by pulling /
pushing down on the Red lever marked 'EMERGENCY".
The Red "CALL PLACED" L.E.D. indicator shall light to assure the
resident that the call has been placed. Switching mechanism shall
consist of a reliable DPDT switch. The WES555 shall be used in
conjunction with the WSM555 wireless support module.
When used with a "check-in" pushbutton such as the SF113, the
WSM555 needs to be replaced with the WSM555-2 dual input
version.
The WES555 is typically used as a toilet emergency pull station
and is not designed to be used in wet or damp environments. For
wet or damp (or shower) type applications use the model#
WES537 station instead.
All electronic components needed for these features shall be
mounted on a printed circuit board and all station components
shall be mounted an a rugged ABS plastic faceplate. The station(s)
shall be installed in a single gang ring with square box. Plug-in
connectors shall be provided for connections.
Contractor shall observe all local and national electrical and
building codes.
WES555 Emergency Pull/Push StationWES555 Emergency Pull/Push Station
The Alpha Communications® WES555 Emergency Station may be
used in any location where activation of an emergency signal is
required. All electronic components are mounted on a circuit board.
The WES555 features a built-in Red LED 'call-placed' indicator, and
6 foot nylon pull cord.
Due to the flexibility of its design, it may be used as a PULL CORD
EMERGENCY STATION, OR a PUSH TYPE EMERGENCY STATION. The
pull cord supplied may be used for emergency call activation or if
so desired, the LARGE RED push/pull down lever may be used.
The WES555 is used primarily with the WES555 Wireless Support
Module on the AlphaEcall™ 200 series wireless emergency-call
system(s), but can be used and is backwards compatible with
some older systems as well, as well as the AlphaEntry™ series
(v5.5 or later).
FeaturesFeatures
Simple and flexible operation.
RED L.E.D. "Called Placed" indicator
Call cancel only at point of origin.
Flame Retardant type ABS White Plastic Faceplate
Can be used as a Pull or Push type station
SpecificationsSpecifications
Dimensions:
Height: 4.50" (114mm)
Width: 2.75" (69mm)
Depth: 1.75" (44mm)
Projects: 0.44" (11mm) from mounting surface
(less IH527 back box)
Mounting:
Surface mounts (along with the WSM555 support
module) using the IH527 surface back box
Construction:
Flame retardant type ABS plastic
faceplate. Switches and electronic components
are circuit board mounted.
Connections: Plug-in connectors.
Required ComponentsRequired Components
AlphaEcall™ 200 Master Station(s) and system components
WSM555 Plug-in Wireless Support Module
Optional ComponentsOptional Components
IH527 Surface (White) plastic back box
CA016K Thermoplastic Polyurethane (TPU) plastic pull cord
sets