User`s guide

3. Power Supply Installation
24
164201085 Rev. F0
3.1.1 ZTT/Plus Chassis Installation
INSTALLATION PROCEDURE
CAUTION: The maximum ZTT/Plus chassis weight is 60 lb, and the center of
gravity is offset to the right. The lifting lugs on the top may be used to
raise the chassis with the proper equipment. All appropriate safety
precautions must be taken to prevent serious personal injury.
WARNING: Verify the DC circuit breaker is in the OFF (down) position and the AC
circuit breaker is in the OFF position before proceeding.
Optional
Remove the inverter module from the ZTT/Plus chassis and store in a secure
location. This module reduces the total chassis weight by approximately 6.5
pounds.
Optional
The upper front door of the outdoor cabinet may be removed for ease of installation.
The LED cable clamp is installed for easy reassembly. Alternatively, the upper front
door can also be held open without being removed (see Figure 3–1). Lift the
cabinet top, open the front cabinet door upwards and place under the lip of the
cabinet top.
3.1 Installing the ZTT/Plus
Fig. 3-1 Opening the Cabinet