User`s guide

2. Cabinet Installation

164201085 Rev. F0

INSTALLATION PROCEDURE

1. Install an appropriate disconnect box between the AC power source and the cabinet

mounting point. Wire to the power line in accordance with local codes.

2. Remove all equipment, hardware, and options from the outdoor cabinet and store in a

secure location for future use.

3. Remove the U-shaped mounting bracket from the cabinet rear panel (see Figure 2-2).

4. Use the bracket as a template to mark mounting holes at the desired mounting location.

If possible, position the cabinet so the front panel and optional LEDs are easily visible.

5. Drill 11/16" holes in the pole at the marked locations.

6. Attach the mounting bracket to the pole using 5/8" hardware (not provided). Tighten

securely.

7. Optional band mounting for metal/cement poles: insert the metal bands or straps (not

provided) through the band slots on the mounting bracket. Tighten the bands securely.

8. Raise the cabinet and set into place on the bracket. Attach the cabinet using the

hardware removed in step 3. Tighten the bolts securely.

9. Confirm availability of a suitable ground rod next to the power pole. If required, drive a

rod according to local codes, and connect to the utility disconnect box and the

enclosure grounding lug.

NOTE On some products, the cabinet bracket may be one piece instead of two (as

shown), and the number of mounting screws may vary.

2.1 Pole-Mount Cabinet,

continued

Power Meter

Fig. 2-1 Utility Disconnect