Operator`s manual

164201257 C0 Page 35 6/13/2003
Preliminary
Lectro CPR
®
Operator’s Manual
4.4 Maintenance
4.4-1 Test the CPR Communicator for the correct signals by monitoring the specific CPR
module at the headend.
4.4-2 Simulate the “General Alarm” signal by removing the plug (or shorting jumper) on the
front of the CPR module. Verify this alarm is received at the headend.
4.4-3 Check all wiring connections. Refer to Section 2.1.
The CPR Communicator Module should be tested and the connections checked on a
regular basis. This should be performed at least once a year. Other than the two sim-
ple steps, described above, there is no routine maintenance required for the CPR
Communicator module.