Operator`s manual

164201257 C0 Page 13 6/13/2003
Preliminary
Lectro CPR
®
Operator’s Manual
2 : Power Supply
2.1 Installation
Refer to Section 1 for installation of the pole mount or ground mount enclosure.
NOTE: The CPR module weighs 56 lbs/25 kg. (65 lbs./30 kg for the 24 amp model), and the
center of gravity is offset to the right. The unit may be lifted using both of the lifting handles
on the front of the module.
CAUTION: When pulling the unit forward from a shelf, be sure to support the right hand rear
corner.
Figure 2.1-1: CPR Cabinet-Completely Wired
2.1.1 Verify the battery breaker on the front panel of the CPR is open.
2.1.2 Connect the green and yellow output harness on the CPR UPS to the mating
connector on the harness that is installed in the cabinet. Verify the wire colors
and connector
colors match.