Manualshelf

Operator`s manual

ManualsBrandsAlpha ManualsConsumer electronicsLectro 87V
11121314151617181920
164201257 C0
Page 11 6/13/2003
Preliminary
Lectro CPR
®
Operator’s Manual
Typical Placement of Disconnect Breaker
on Rear of Cabinet
“Feed Thru”
A
daptor at Rear
of Bottom Shelf
Coax
Seizure
Clamp
“Snap in”
Connector (to
power supply
output)
Figure 1.2-5: Coax “Feed Thru” Adapter Normal Location (Bottom Shelf)
1.3 Electrical Connections
WARNING: Be sure the utility (mains) disconnect is off and that no conductors are ener-
gized before proceeding.
To connect wiring, perform the following steps:
1.3.1 Open the cabinet doors.
1.3.2 Install liquid tight conduit to the fitting on the cabinet rear panel and pull the AC
primary into the cabinet housing.