Data Sheet

Product Specification Sheet APS319 - Rev. 08/2013
IH101 Flush Steel Mounting Box - vertical mounting
42 Central Drive • Farmingdale • NY • 11735-1202 • Phone: [phone] • Fax: [phone]
TOLL-FREE: [phone] • Web: AlphaCommunications.com • Email: [e-mail]
Copyright© 1998-2014 Alpha Communications® - All Rights Reserved.
Due to continuous product improvement, all colors, sizes, materials, finishes and specifications are subject to change without notice.
< Previous (APS318) Next (APS320) >
IH101 Flush Steel Backbox IH102 Flush Steel Mounting Ring
Dimensions
IH101:
(wall opening required)
Height: 5.63" (144mm)
Width: 4.00" (102mm)
Depth: 1.75" (45mm)
IH102:
(wall opening required)
Height: 5.40" (138mm)
Width: 4.10" (105mm)
Depth: 0.50" (13mm)
IH101 Flush Steel Backbox & IH102 Flush Steel
Mounting Ring
The Alpha Communications® models IH101 and IH102 are flush
steel mounting boxes and rings, made of heavy gauge steel, in a
galvanized finish. They are our most popular mounting
accessories, and are used with a variety of flush mount
intercom remote and master stations.
The IH101 is a fully enclosed box, designed to be nailed or screwed
to a mounting stud, or set into concrete or masonry.
Convenient knockouts on the top and bottom of the box, make it
easy to attach to standard electrical EMT box connectors.
The IH102 is an open design mounting ring, designed to be used in
existing sheetrock or panelled walls, where the unit cannot be
mounted onto the stud. As a lower cost option on new
construction, it can also be nailed or screwed to a mounting
stud, before the sheetrock is applied.
Architects' And Engineers' Specifications
The flush back box/ring/housing shall be Alpha Communications® /
TekTone model IH101 or IH102 or approved equal. It shall be made
of heavy gauge steel, in a galvanized finish. The IH101 shall
contain convenient electrical knockouts on the top and the bottom
of the box, to attach to standard electrical EMT box connectors.
The IH102 shall be open in the back to allow for equipment
clearance and wiring if needed.
Contractor shall observe all local and national electrical codes.