System information

18
JP3
JP3
Open
Pushbutton 1 through 6 interlocked
JP3
Short
Pushbutton 1 through 6 non-interlocked with each pushbutton becomes single-speed contact
JP4 (F3 & D3 models only)
JP4
Open
No acceleration delay from 1
st
through 3
rd
speed (Alpha 3000F-3 & D-3 models only)
JP4
Short
1
st
speed
pressed
After 1
second
1
st
speed contact
relay engaged
2
nd
speed
pressed
After 1
second
2
nd
speed contact
relay engaged
3
rd
speed
pressed
After 1
second
3
rd
speed contact
relay engaged
6
6
.
.
2
2
S
S
e
e
c
c
u
u
r
r
i
i
t
t
y
y
I
I
D
D
C
C
o
o
d
d
e
e
S
S
e
e
t
t
t
t
i
i
n
n
g
g
s
s
Transmitter ID code can be readjusted via an 8-position soldering slot (the first 8 digits of the ID code) and
an 8-position dip-switch (the last 8 digits of the ID code). Please refer to item # 7 on page 5 and item # 8
on page 7 for the location of the soldering slot and dip-switch on the encoder board. As for the receiver ID
code setting, the soldering slot and the dip-switch are located inside the decoder module; please refer to
item #3 on page 9 & 10 and below
illustration.
(Decoder module internal view)
Please note that the first 8 digits of the ID code can be changed by soldering the two points together (“1”
value); the position is at “0” value when left unsoldered (two points open). The last 8 digits of the ID code
are set via an 8-position dip-switch located next to the 8-position soldering slot.