System information

17
6
6
.
.
S
S
Y
Y
S
S
T
T
E
E
M
M
C
C
O
O
N
N
F
F
I
I
G
G
U
U
R
R
A
A
T
T
I
I
O
O
N
N
S
S
6
6
.
.
1
1
J
J
u
u
m
m
p
p
e
e
r
r
S
S
e
e
t
t
t
t
i
i
n
n
g
g
s
s
There are numerous functions that can be set via jumpers located inside the decoder module. Please see
the diagram and chart below on how to set these
functions.
Manufacture Setting
Open
After inserting the transmitter power key at system startup, or after EMS
reset, press and hold START/AUX to activate the receiver MAIN relay.
JP1
Short
Insert the transmitter power key will immediately activates the receiver
MAIN relay. After EMS reset, re-insert the power key to reactivate the receiver
MAIN relay.
Open
After 5 minutes of transmitter non-usage the receiver MAIN relay will be
deactivated.
JP2
Short
Receiver MAIN relay stays on constantly until the main power source to the
system is turned off.
Open
Pushbutton #1 through #6 interlocked (U/D, E/W, N/S).
JP3
Short
Pushbutton #1 through #6 non-interlocked with single-speed relay contact.
Open
No acceleration delay from 1
st
through 3
rd
speed (F3 & D3 models only).
JP4
Short
Acceleration delay for up to 1 second from 1
st
through 3
rd
speed
(F3 & D3 models only).
Note: Every time when you change jumper settings you must first turn the receiver power “off” and then turn it
back “on” after setting so that they can be stored in memory.
JP1
JP1
Open
Insert the transmitter
power key
Press and hold
START/AUX
Receiver MAIN
activated
OR
After EMS
reset
Press and hold
START/AUX
Receiver MAIN
activated
JP1
Short
Insert the transmitter
power key
Receiver MAIN
activated
OR After EMS reset
Re-insert the transmitter
power key
Receiver MAIN activated
JP2
JP2
Open
5 minutes of transmitter non-usage Receiver MAIN deactivated Press any pushbuttons Receiver MAIN reactivated
JP2
Short
Receiver MAIN stays “on” constantly until the main power source to the system is turn “off”