Specifications

• Manual Operation

Application

Manual charging with partial or full load, for example for calibration or linearization.

Procedure

Start the test.

By pressing START once more the control unit switches from CHARGE

to MANUAL STOP and stops the ramp.

MANUAL UP 1..4

Slow run up with step 1. By pressing the key again you can raise the step.

MANUAL DOWN 1...4

Reduction of step UP to step DOWN by repeatedly pressing this key.

Slow run down to step 1. By repeatedly pressing the key you can raise

the step DOWN. Reduction of step DOWN by ↑.

MANUAL STOP

With this key you can stop at any time.

Setting of the steps:

Step 1: 0,01 % Step 2: 0,25 % Step 3: 1,0 % Step 4: 5 % of the max. force

Page 30

START

SET