Specifications

The following inputs are possible:
cube stone
prism 3-point beam 3-point
pressure prism beam pressure
prism 4-point beam 4-point
plate off
cylinder
rod
rod
Conversion input: conversion factor in order to display and print out e.g. the strength with 95%.
As soon as another value than 100% is set for the conversion it is displayed by a "*" in front of
the specimen type.
Measure input: cube: max. 999 mm side length (edge)
prism: max. 99999 mm² face
cylinder: max. 999 mm diameter
plate: max. 999 mm length, max. 999 mm width
- Read Storage:
By pressing the key ENTER the output of the stored data to a PC which is connected by the COM-in-
terface is effected.
For each specimen the settings for the print-out, the type of specimen, the measuring results and the
calculated strength are stored and output.
The data are only stored by the manual pressing of the key DATA at the end of the test or automatically
after the the detection of the specimen’s break (when “break detection” is activated
– option)
The data of the specimen can be transferred to the PC by a serial COM-interface and can be stored at
the same time.
- Delete Storage:
All stored specimen data are deleted by pressing the key ENTER. The storage is reset to the initial value.
After having read the data the storage should be deleted so that the system is ready
for the next tests.
- Free % 100:
Indication of the free storage in %.
100% - the storage is empty
0% - the storage is full, no more data can be stored.
Page 25