Specifications

• Test course with measuring and weighing
1. Select the specimen type with CALC.
2. Start the test by pressing START, the measuring screen is invoked.
3. Input the dimensions or measure them.
4. By means of the key START return to the test screen and carry out the test.
5. Combined with a printer a print-out is effected automatically after rupture if the break detection is
activated.
6. Without measuring/weighing of the specimen the measuring invocation can be omitted by key EX.
Key FNC
In case of selected specimen type you can - after the test -switch over from N/mm² to kN by pressing
key FNC.
The correct display of the load pacer is important, as the specimen is charged according to this:
N/mm² kN
N/mm²/s kN/s
In case of specimens with selected conversion factor the breaking load is indicated furtheron with
100%.
Without Selection of Specimen
Measuring and weighing is inhibited.
Page 16
.
FNC
.
FNC