Specifications

Page 3
• General view
Type of device:
Real digital control unit which has been developped for all types of testing machines. Expandable to a fully
automatic testing system in connection with balance, sliding caliper, measuring station and computer.
Selection of the machines:
The device is structurally divided in max. 4 machines. All settings can be made separately for each
machine.
Exceptions: specimens’ conguration and print-out inputs.
Operation:
At rst select the respective machine.Then make all settings with the main menu. These settings are being
preserved by a memory even after switching-off the device. For the securing of the machine’s functions
"plant" and "calibration" are code-protected.
Specimens’ conguration:
The 30 most frequent types of specimens with dimensions and loading speed can be memorized under
menu ‘’Specimens’ conguration’’.
Test procedure:
Select the desired specimen’s type with push-button CALC and start the machine.
If a specimen is tested which has not yet been programmed you have to input the test course under menu
‘’ramp’’. During the test the screen indicates the load in kN. In case of respective measuring systems an
additional displacement or deformation display is possible.
Under ‘’test’’ free-programmable test courses are possible(only valid for C20).
Computer interface
By the serial interface of DIGIMAXX there is a full compatibility to the complete material testing software
PROTEUS. Only some possibilities of this testing system are mentioned with the complete operation by
computer and the graphical recording during the test.
Memory (option)
This memory allows a testing at the DIGIMAXX and then a subsequent transmission of the specimens’
data to the connected computer.