Operating instructions

7.1 EMERGENCY MANUAL OVERIDE SYSTEM
FOR SECTIONAL AND TIP-UP TYPE DOORS
Traveller lever in the
"Horizontal Position".
Traveller lever in the
"Vertical Position".
TRAVELLER
ENGAGED.
TRAVELLER
DISENGAGED.
The "pro-alpha" door operator, unlike many
other types of operators, is able to secure the
door even if the power supply is switched "OFF".
When the Traveller-Lever is in the engaged
position, the door will automatically be
locked.
TO OPEN THE DOOR:-
See Sections 10 & 11 "OPERATOR TESTING"
and OPERATOR FUNCTIONS".
7.3 SECURING THE DOOR:-
Fig No. 26
garage door operator
Before operating the door automatically...
make sure that the door locks are
disengaged and are secured in the
"OPEN" or "UNLOCKED" position.
7.2 HOW TO RECOUPLE THE
OPERATOR TO THE DOOR
Do not try to open the door by pulling "Red
Cord". Use the door handle !!!
SECTION 7
HOW TO OPERATE THE ..........
EMERGENCY MANUAL OVERRIDE SYSTEM
OF YOUR
"pro-alpha 2000"
In the event of a power failure or other breakdown
which renders the garage door operator
unserviceable, a simple, easy-to-operate
"Emergency Manual Override Mechanism" is
provided for on the "pro-alpha 2000" gdo.
Attached to the Traveller is a Red Nylon Cord
with a Red Hand-Grip fixed to it.
A red card, labeled "Emergency Operating
Instructions" is attached to the cord.
The Red Cord operates the emergency override
system.
*
*
*
IMPORTANT NOTE! ....
Fig No. 27
TRAVELLER
ENGAGED.
PULL
"pro-alpha 2000"
PULL
RED CORD
"pro-alpha 2000"
First! ... Close the door manually.
Next! ... Push the Traveller Lever to the
"engage" position.
As soon as the power supply is
restored, the "pro-alpha 2000"
Door Operator will automatically be
ready to operate the garage door.
Now! ... Check the door and operator for
correct operation.
First! ... Switch the electrical power supply
"Off" .
Next! .... Pull the red Release Cord vertically
downwards. The Traveller Lever will
move to the "dis-engage" position.
Then! ... Lift the door up by it's handle.
To disengage the motor from the door, pull
the Red Cord vertically downwards as
shown in Fig. 26
To "re-engage" the "Traveller", pull the
"Red" cord towards the "Motor-head" as
shown.
The "Traveller Lever" must be in the
horizontal position in order to re-couple the
operator to the door.
MAN 01 - page 12
Version 5